Windows & glass
How do I clean windows without streaks?
Streaks are cleaner, dirt or water drying on the glass before you remove it. Pros wet the glass with a strip washer, pull the water off with a sharp squeegee, and dry the edges with microfiber. For smaller jobs, a light homemade vinegar cleaner or a glass cleaner wiped completely dry also works.
Why it happens
Streaks form when cleaning solution, loosened dirt or water dries on the glass instead of being removed. A worn or nicked squeegee blade, pressing too hard on the squeegee, and dirty or linty cloths all leave lines behind.
Strip washer and squeegee (the pro method)
No reviews yet. Tried it? Be the first.
What you need
- Bucket
- Glass cleaning agent, dosed as its label says
- Strip washer (microfiber sleeve)
- Squeegee with a sharp, undamaged rubber blade
- Two microfiber cloths
- Glass scraper (optional, for stuck-on spots)
Tips
- Unger says to change the squeegee rubber after about 15 hours of use, or sooner if it streaks or has a nick.
- Make sure the scraper blade is rust-free before using it.
Steps
- Fill the bucket with water and add the cleaning agent at the dose on its label.
- Wipe the window frame first with a damp cloth so dirt doesn't run onto clean glass.
- Wet the whole pane with the washer using an S-shaped motion. Use the scrub side on stubborn dirt.
- If needed, scrape stuck-on spots while the glass is still wet: light pressure, top to bottom only, then retract the blade.
- Put the squeegee on the top edge at about a 45-degree angle and pull it across and down in an S (wave) pattern without lifting it off the glass. Let the squeegee's weight supply the pressure; pressing harder causes streaks.
- Soak up the leftover water along the top, bottom and side edges with a microfiber glass cloth, then wipe the sill.
Where this comes from (3)
- Squeegee Window Cleaning: How To for a Streak Free Shine (opens in a new tab) Unger Enterprises
- Getting it right: How to achieve streak-free windows using a washer and window squeegee (opens in a new tab) Unger
- ShowerGuard Glass Enclosure Care and Cleaning Guidelines (opens in a new tab) Guardian Glass (Gujarat Guardian Limited)
Homemade vinegar and cornstarch glass cleaner
No reviews yet. Tried it? Be the first.
What you need
- 1/4 cup white vinegar
- 1 tablespoon cornstarch
- 1 quart warm water
- Spray bottle or sponge
- Dry cloth (the extension recipe suggests crumpled newspaper)
Steps
- Mix 1/4 cup white vinegar, 1 tablespoon cornstarch and 1 quart warm water.
- Apply to the glass with a sponge, or pour into a spray bottle and spray.
- Wipe dry, then buff to a shine.
Where this comes from (3)
- Green Cleaning: No-Streak Glass Cleaner (opens in a new tab) N.C. Cooperative Extension, Stokes County Center (NC State University)
- Dangers of Mixing Bleach with Cleaners (opens in a new tab) Washington State Department of Health
- Learn About Cleaning Products for Natural Stone (opens in a new tab) Natural Stone Institute
Glass cleaner or a dilute ammonia solution, wiped dry
No reviews yet. Tried it? Be the first.
What you need
- Glass or glass-and-multi-surface cleaner, OR 1/2 cup ammonia in 1 gallon of water
- Sponge or cloth
- Clean damp cloth for rinsing
- Clean dry cloth, paper towels or a squeegee
- Piece of cardboard or a cloth to shield the frame
Tips
- To clean a frame or sill, spray the product onto a cloth rather than onto the frame.
Steps
- Remove dust, cobwebs and insects from frames and sills first with a small brush or a vacuum brush attachment.
- Spray the cleaner onto the glass, not the frame. Hold cardboard or a cloth against the frame while you spray.
- If using the ammonia mix, wipe the glass with a sponge wet with the solution, then rinse with a clean damp cloth.
- Dry with a clean dry cloth, paper towels or a squeegee.
Where this comes from (2)
- Clean Windows (opens in a new tab) American Cleaning Institute
- Dangers of Mixing Bleach with Cleaners (opens in a new tab) Washington State Department of Health
Know a better way?
Suggest a solution we haven't listed. We check every suggestion against a trusted source before adding it.